Sabre 1848HV Manual del operador descargar pdf (Pagina 10)

Assembly - Page 6

ASSEMBLY

9. Put mower drive belt (E) on engine drive sheave.

10.Push drive belt tension rod (F) into bracket (G).

11.Raise mower lift lever to TRANSPORT (upper)

position.

12.Remove wood blocks from both sides of mower.

13.Level mower. (See Leveling Mower in Operating the

Mower section.)

Install Mower Discharge Chute

1. Install mower discharge chute to mower deck with two

M8 x 20 bolts (A) and lock nuts (B).

2. Tighten nuts to 20 N•m (15 ft-lb).

Break-In Electric PTO Clutch

1. Start engine and push throttle lever (A) up to full

throttle (

) position.

2. With no load on mower, ENGAGE PTO (B) and allow

mower to run for 10 seconds.

3. DISENGAGE PTO and wait 10 seconds.

4. Repeat Step 2 for 12-15 cycles.

5. PTO clutch is now properly burnished.

CAUTION: To avoid injury:-NEVER operate

mower without chute in place.

-Hold chute firmly on mower deck when

installing, mower discharge chute is spring

loaded.

-After installing chute on deck check to make

sure hinge on chute is working properly by

opening chute and releasing it. Chute MUST

spring back to the LOWERED position.

M88579

M47397

M88557

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 99 100

Sin comentarios

Sabre 1848HV Manual del operador Pagina 10